Cement silo installation steps
Home > Uncategorized > Cement silo installation steps

Henan Oriental perennial mass production of conventional models of  Bolted Cement Silo, cement silo contains: the warehouse roof parapets, outside ladder, lower extremity retreat break Gong, discharge valves, angle iron, dust collector, screw. cement silo aeration pads,Perennial supply of major domestic cement factories, motor transport, short lead times, all over the country have aftermarket installation services personnel.
The cement silos China installation steps: car installation site, first remove the cement silo ladder, fences and other objects. Then connect the legs to the cement silo, find matching angle iron link to the leg, remember to add pads installed unloader valve, installed under the feed tube connecting the mouth to remain closed state. Be sure to add the pad, and tighten the screws. Installation precipitator assembly cement warehouse top guardrail installation ladder. Reinforcement of all the screws on the cement silo.
Finally, look for the crane upright cement silo, In the early days of welding, we must ensure the verticality of the positions error is as small as possible, and then reinforced cement silo feet firmly welded with a welding machine. Triangle to four legs good reinforcement. Note: in the legislation before the cement silo, must screw tight, welding welding error not ex firmly positions the vertical degrees up and down the greater than 1 cm. Note lifting during high-altitude wire pay attention to the safety of personnel.

2013 new Bolted Type Cement Silo manufacturer

Bolted Type Cement Silo manufacturer

 

Dust collector Installation

Dust collector Installation

Dust collector Installation

Dust collector Installation

Dust collector Installation

Dust collector Installation



Previous:
Next:
Weboy